[Teddis]

The hits keep coming !
Awesome video, thanks for all you do !

 

[Teddis]

I had a PDK fluid change at dealer , year or so back …..will dig it up….see if adaptions were performed.

 

[Teddis]

Thank you @Santirx for this excellent DIY video. I was able to complete the PDK 3 stage calibration per your instructions perfectly.

I also did the Transfer case Integrator reset and Angle teach. My pre and post Val’s showed less than 1 degree of change after calibration. I would assume my Tx case clutch is in good shape.
Cheers !

 

[Teddis]

Nonsense....you need to run the Cal after a fluid change.

 

[Teddis]

Were you able to complete the transfer case “Angle re learn” procedure as well as Integrator reset ?

 

[Teddis]

You would know, seperate calibration listed in the AWD section. NOT PDK.

 

[Teddis]

Sorry to be more detailed, in the Lite, it just lists Transfer Case Service, but during the process, it does go through some kind of calibration, takes a few minutes and you do hear some mechanical noises happening under the car. I can't recall if the description says calibration though.

sounds like it, nice.

 

[Teddis]

The temp range is in the video by @Santirx

 

[Teddis]

its a VCI issue I believe. I have calibrated my TX case more than once. I use the T6

 

[Teddis]

What tool did you use ???

 

[Teddis]

Yes, i had the same failures.....you mean the lower window pane, correct ?